Is it reusable?
Why use only stainless steel?
Floodwater can be an extremely powerful force. We therefore decided to use the strongest possible material. We also found that a Ventguard made of plastic could not take the pressure required to push the sealing membrane into each airbrick hole - the plastic would eventually crack. In addition, a plastic cover could be damaged by floating debris during a flood and water might then enter through the airbrick.
How does the Ventguard attach to the vent/airbrick?
Stainless steel is extremely strong and can withstand great pressures.
The special threaded catch consists of a thin threaded stainless steel rod with a weighted swivel toggle on the end. This catch is actually a piece of precision engineering and is the most vital part of the whole device. This catch goes through one of the airbrick holes and grasps the back of the airbrick. To make the toggle grasp the back of the airbrick you turn rod in a clockwise direction - the Ventguard can then be tightened against the airbrick. To remove the Ventguard the rod is simply turned anti-clockwise, the toggle releases and the Ventguard can be removed. This whole operation takes about 30 seconds. Full instructions are provided.
Has it been tested?H

We have conducted our own independent tests. In a one metre still water test with the plate tensioned so that the sealing membrane entered the airbrick holes, there was found to be no leakage. In an outdoor test, a Ventguard was attached to an airbrick which was set in a house wall with a pebble dash finish. It was then subjected to water flow from a pressure washer. There was no water penetration through the Ventguard.

Ventguard can be used time and again. All parts are replaceable should they get lost or damaged. We always have a stock of spare parts.
How long does delivery take?
Delivery is normally within 48 hours.
How do I place an order?
You can order by phone on 01382 779706. You can also purchase through this website by clicking HERE
What type of vents /airbricks does Ventguard fit?
Easifit Ventguard is not suitable for plastic vents or horizontal louvre vents. Ventguard fits standard vents/airbricks either in double brick (9x6) or single brick size (9x3). The number or pattern of holes in the airbrick does not matter - the Ventguard will fit so long as there is a hole at or near the centre of the airbrick. The Ventguards are slightly larger than the airbricks which they fit so the fixing hole need not be exactly in the centre of the airbrick
F.A.Q.